Apron flashing

SSMAPRON

Roofing trim · headwall

Project pricing

Bent to your roof detail

Apron flashing is fabricated to your job — send the sizes and pitch and we’ll quote it fast. That’s where we do our best pricing.

Get project pricing Call 765-432-4157

Custom order form

Spec sheet (PDF) Custom order form & drawing Color chart Finish warranty Install guide Request a takeoff

OverviewMaterialsSizes & profileInstallationColors

Apron Flashing at the headwall — wall leg under the wrap, kicked lower edge stands off the roof

Seals the headwall joint

Wall leg goes under the wrap / siding

Kicked lower edge sheds onto the roof

Cut to your pitch

24 & 26 gauge steel

29 standard colors

Up to 10′ lengths

Fabricated to your drawing

Apron Flashing closes the joint where the roof runs up into a wall: the wall leg tucks under the weather barrier, the roof leg comes down the slope, and the kicked lower edge stands the water off the roofing. Bent to your pitch, gauge, and color.

Apron flashing is fabricated from steel and finished in your choice of standard or custom color with a durable factory paint finish. The substrate carries the mill’s coating; the paint finish carries the coating manufacturer’s warranty. Tell us your color and gauge and we’ll match the job.

Gauge24 / 26 ga

Color chart Finish warranty

Standard profile shown — every apron is bent to your roof detail. Send dimensions and we’ll quote it fast.

Bend anglesStandard or noted

LengthUp to 10′

Miters & splice platesOptional — ask us

Custom order form All drawings

Step-by-step install for Apron flashing — laps, fastener spacing, sealant, and the transitions where it meets panel, wall, and valley. Open the full guide:

Open the install guide Request a takeoff

Available in every color on the SSM color chart — 29 standard colors plus custom finishes, color-matched to most manufacturers. Bare galvalume and galvanized are available too.

View the full color chart Try colors on a building